Montane Flux Jacket

The Montane Flux jacket offers just the right amount of insulation so that it is warm enough to make a noticable difference of a cold day without the bulk and weight of a full on winter jacket.

The Montane Flux retails a closer fitting cut and relatively close fitting arms so this is not a jacket for bulking up with thick layers, but if you are looking for a jacket that suits active use then the Flux is ideal.

Compare it to a fleece of comparable warmth and the advantages of the Montane Flux are obvious:

• Windproof
• Showerproof
• Lighter
• Lower packed volume

Featuring a full specification, technical hood, four pockets and using 60g PRIMALOFT in areas where maximum insulation is required and 25g PRISM for ultimate packability, the Flux is an intelligent synthetic insulated jacket.

The Montane Flux is extremely breathable, lightweight, low bulk and retaining good thermal performance even when wet, so it is versatile, easy care insulation for year round use.

Montane Flux Details

• Dual density zoned insulation with internal baffle anchors
• Full length, reversed and baffled two-way front zip
• Two zipped chest pockets
• Two zipped, insulated hand warmer pockets positioned clear of waist-belt or harness
• Roll-down helmet hood, with wired peak, volume adjuster and single hand operated non-whip face aperture draw-cords
• DWR Beardguard chin guard
• Part elasticated, hook and loop adjustable cuffs
• 3M Scotchlite reflective flashes
• Provides thermal insulation of 2.0 tog
• Stuffs into own pocket

Montane Flux Fabric

Outer: PEAQ Micro
- 49g/m² extremely lightweight Nylon 6 rip-stop
- Breathable to 92%
- Dense weave gives a wind resistance of 0.3cm²/sec
- Water repellent with a spray rating of grade 4
Interlining 1: PRISM 25g
-(Front and sides 2 layers of 25g, cuff area, sides of hood)
- 25g/m² high performance synthetic mid-loft insulation
- Provides thermal insulation of 1.0 TOG
- Warm when wet and fast drying
- A unique blend of ultra-fine and multi functional fibres providing warmth and a soft compressible loft
Interlining 2: PRIMALOFT 60g
-Shoulders and back, sleeves - other than cuff area, top and back of hood)
-60g/m² high performance synthetic mid-loft insulation provides thermal insulation of 2.0 tog
- Wind resistant, water repellent, fast drying and breathable
- Retains warmth when wet
- Compresses like down
Lining / E.B.P: PEAQ Air
- Lightweight Nylon rip-stop
- Water repellent
- Wind resistant
- Extremely breathable
- Ideally suited to areas where maximum breathability is key such as Enhanced Breathing Panels (EBP)



Video Presentation